Wind Gauge and Wind&Height Controller
Wind & Height Controller of WorldWind 32/42 ( model : MCNT-32 ) allows user set up a target height and wind speed for pulling UP/DOWN a tower when wind blows hard.
To use these functions, Wind Gauge should be purchased optionally and installed on controller.
To use these functions, Wind Gauge should be purchased optionally and installed on controller.
Feature
- 10mm unit heigth-setting
- Target height and wind speed could be set by users
- For the variable user's environment (climate), terminals for connecting heater and cooler are on controllers.
- Calibration of Wind Gauge : When initial installation, users proceed the calibration in person, which is useful in variable user's environment.
Example of Use
[ Condition ]
1. Model : WorldWind32 (Tower’s maximum height : 32m)
2. Wind Gauge installed
3. Height of tree or roof : 6m
4. Current wind speed : 10m/s
[ Operating ]
If you want to pull down the tower to 6.5m when the wind speed is over 25m/s, you could control it as following the operating direction to program on MCNT-32 or RCNT-32.
[ Condition ]
1. Model : WorldWind32 (Tower’s maximum height : 32m)
2. Wind Gauge installed
3. Height of tree or roof : 6m
4. Current wind speed : 10m/s
[ Operating ]
If you want to pull down the tower to 6.5m when the wind speed is over 25m/s, you could control it as following the operating direction to program on MCNT-32 or RCNT-32.